When exporting a model made with the 3d mechanics editor to matlab, the following problem shows up.

The model fails to run because a function "xxinvhomogeneous" is missing. Upon inspection, there is indeed no such function anywhere in my code, but there is a function "xxinversehomogeneous". Am I right in assuming that the latter is the one which is needed?

As far as I can tell, the code runs fine when changing xxinvhomogeneous into xxinversehomogeneous, but I might be wrong; I'm still having some problems using my model in Matlab.

## Exporting code to matlab

**Moderators:** Frank, paul, Hiwot, Chris, peter

### Re: Exporting code to matlab

jvkersch wrote:When exporting a model made with the 3d mechanics editor to matlab, the following problem shows up.

The model fails to run because a function "xxinvhomogeneous" is missing. Upon inspection, there is indeed no such function anywhere in my code, but there is a function "xxinversehomogeneous". Am I right in assuming that the latter is the one which is needed?

As far as I can tell, the code runs fine when changing xxinvhomogeneous into xxinversehomogeneous, but I might be wrong; I'm still having some problems using my model in Matlab.

Thanks for the bug report! That is indeed the function that you need to use.

What integration method do you use in 20-sim and in Matlab?

member 20-sim development team

### Re: Exporting code to matlab

paul wrote:What integration method do you use in 20-sim and in Matlab?

If I'm not mistaken, it's BDF. To get some hands-on experience, I just wanted to simulate a falling body so I took a standard body and a sensor for the z-coordinate; I didn't change any of the standard experiment parameters.

### Who is online

Users browsing this forum: No registered users and 4 guests